Skip to ContentRC is a robotic mower
RC Series
How can I find disconnections in the wire installation loop?
Try this solution
Follow one of the guides
1.
Disconnect one end of the perimeter wire from the Plot connector (green connector).
2.
Make sure the Base Station Board / Perimeter Switch / Power Box is ON.
3.
Set the radio to AM frequency, so that no broadcasting is detected and only “white” noises are heard.
4.
Start walking along the wire (the edge that is still connected to the board and not the edge that was disconnected out). Open the antenna and walk along the perimeter while the antenna is close to the ground. As long as the wire is not broken, there will be consecutive beeping sounds, which will stop where the cut wire is.
Follow the step-by-step guide to find broken wire by small sectors.
Need more help?
On this page